I had to modify the train handle ebrake that runs through the floor in the 46 but 47-72 guys wont have an issue. A flat piece of steel welded to the front will capture the T5 mounting holes. crossmember and re used it, just slid it back. Trimmed the carpet and now need to fill the old hole with a cup holder or have new carpet cut and bound. Measured the shifter hole and a 3 inch hole saw did the trick. I ordered a jeep input shaft with 10 splines ( p/n 1351-085-008) and shortened the tip with a bevel and shortened the throw out bearing collar to the same distance as the 3 speed one. The T5 is 3 inches longer than the 3speed so have the driveline shortened ahead of time. Im going to run a 4l60 later so getting a TransX box to covert elect signal to mechanical cable drive speedo was just another needed item. There are a hundred threads on a thousand boards how to do this and it really is about a half day of work once you have all the pieces. I'm running a 55 235 and rear axle for now. The 3 speed in the 46 burb was killing me and couldnt wait any longer for some time to do the ls swap so I pulled the 3 speed and tossed in a T5.
0 kommentar(er)
